Redsail Cutting Plotter Manual de usuario descargar pdf (Pagina 6)

Vinyl Cutter User Manual V5.0

Main parts descriptions

Front side / Left and Right sides

1) Protection cover

2) Carriage

3) Roller

4) LCD display

5) Keypad panel

6) LED lamp

7) Right shell

8) Machine’s foot

9) Blade holder

10) Seat of blade holder

11) Left shell

12) Pinch roll hand level

13) AC power port

14) Safe fuse

15) Power’s switch

16) RS232 port (Serial port)

17) USB port (USB cable)

6 15

Cutting Blade and Plotting Pen

Cutting Blade Holder:

Lock Screw

Blade Holder Shell

Adjustable nose.

Blade tip. (Blade extension)

On the working state, the blade can rotate in holder very smoothly. To change

the blade, unscrew the nose of the blade holder, pull out the old blade and

push the new blade in the blade holder until it hit the bottom then screw the

nose. Let exceed the end of blade about 0,25 mm and perform a cutting test.

The amount of blade extension is optimal when the blade leaves a faint mark

on the base paper.

The distance between the blade end and the media is maximum 1/8” or 3mm.

Adjust the blade holder in the cutter carriage to obtain a the right clearance

and tighten the tool securing screw until the blade holder is secured in place.

Remark:

Do not touch the tip of the blade with your fingers. Doing so may result in

injury. Depending on the material in use, it may be necessary to adjust the tip

of the blade. The amount of cutter blade extension can be adjusted by

rotating the noose cap. Take care to ensure that the amount of blade

extension does not exceed the thickness of the material plus the half

thickness of the base paper.

Vinyl Cutter User Manual V5.0

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios

Redsail Cutting Plotter Manual de usuario Pagina 6

Comentarios a estos manuales